Advertisement

Discuss your PLC and automation problems for Allen Bradley, GE, Omron, Mitsubishi, Modicon, Panel Views, RS View, ABB, Adept Robots, Cognex etc. You can also submit and download sample PLC code.

If our forums and knowledge base still hasn't got your PLC operational, we recommend contacting PDF Supply and Electric for PLC repair and replacement parts.

Email to friend
Multiple emails allowed. Separate with commas

Confirmation code image

Type the characters in the image above exactly as you see them



How-to Test the 1785-BCM Back-Up Communications Module

Hello and Welcome to PDFsupply.com
Today we're going to be testing a 1785-BCM Back Up Communications Module. I have two here, the test will be basically testing the modules ability to pick up if one fails.
So, if this rack fails which is currently in primary, then this rack, or  back up communications module should pick up and take over and vice versa. This way I know that they're able to pick up number one if they're supposed to and number two that both modules are communicating with each other. And we'll probably have a little bit of troubleshooting maybe a couple problems that I see in the field. So, right now the way I have this set up is I have my parallel wiring between the two BCMs and I also have my wiring going from Channel 1A and Channel 1B on the processors. I have two racks set up as just my test lab here this is probably a smaller version of what you have in the field, but there are two 1771-A1B four slot chassis, they're being powered by 1771-P4S power supplies and the processors are 1785-L20B series E They're both L20B- series E they don't have to be if in the field you have an L20 on one side or an L40 or L60 or L80 on the other side it doesn't matter. What's important is that they're both communicating on the same Data Highway Address, that's one tip for you.
So, now that the system is up and running, it is in remote run mode for this test procedure I want to simulate a power failure on my primary rack, now that's important it must be on the primary rack ro make sure that the secondary rack moves itself into primary and knows what to do and when to do it.
I'm going to do that by shutting the power off so please follow. This light here should move to primary when I shut this off and it has, exactly what I want to see. Similarly, when I turn this power back on, my rack that was my primary should jump into secondary and it has. I've turned it back on and as you can see at the tip of my finger here, the LED has moved itself into secondary position. So, these two modules know exactly what they're supposed to be doing and to even further the test I'll simulate a power failure test on this side by shutting this down now and my rack on the left has jumped into primary so little bit of back and forth there but this is telling me that these two processors are communicating properly, they're doing what they're supposed to be doing when they're supposed to do it. Okay, so a couple common failures I see in the field, a little bit of troubleshooting is somebody may have changed the information that's in the processor and it's not communicating properly so some of the troubles we see range anything from communication to module failure and you usually see at the tip of my finger there's the fault light and it will turn red if you have a problem and like I said it could be anything ranging from communication failure or distraction maybe you don't have something terminated or you resistor terminator has broken loose and it's creating a fault and not communicating properly all the way to just basically a bad module. another thing is you want to make sure they're communicating at the same b rate
So a couple things for you to look for pretty easy and I hope you found that this is helpful these are again 1785-BCM is a module that we carry we do have them in stock and we do offer same day shipping so if this is something that interests you please see us at PDFsupply.com Thank You